The Inside range of devices identifies a line of products dedicated to the manufacturers of mass produced industrial gates and doors. Integrating the automation device into the structure of the gate or door allows you to complete the automatic door while still in the factory, thus allowing the manufacturer to supply a complete product that has already been tested and complies with the machine directive.
The automation, available in three versions with different motor power levels automation is suitable for driving sliding gates with up to a maximum weight of 1000kg.
The electromechanical geared motor has been designed to guarantee maximum adaptability when being inserted into the support column of a gate and is fitted with all the fastenings required for every type of solution.
A double-reduction kinetics system immersed in permanently fluid grease works side by side with an efficient low-voltage motor that allows the system to obtain the maximum levels of performance whilst maintaining absolute operating silence when the unit is working.
The geared motor guarantees that the gate is locked in the closed position. The emergency manoeuvre (release system) is carried out by means of an efficient manual release system integrated into the geared motor.
The innovative DRACO system permits the gate's movement to be accompanied with total security and features a “variable speed function” which can be adjusted according to the different installation requirements up to a maximum speed of 30m per minute.
The electronic components are housed in a shockproof plastic container IP55.
Multi-decoding
The product range is factory fitted with a multi-decoding remote control module (system S449 - S486 - S504 - S508). By default the devices are supplied with a 433MHz RF module and the S504 / S508 series memory module inserted. To control the device with S449 transmitters, insert the ZGB24LC16-I / P memory module (supplied with the device) and consult the relevant section. For the S508 / S486 series purchase and insert the 868Mhz RF module.
Compatible with the INTPRG-4G system that allows the system parameters to be controlled and programmed remotely.
A slave motor, connected via cable with the Cardin MODCA slot-in modules inserted, can be installed to drive two biparting sliding gates.
Encoder-controlled 24V self-locking unit - max. weight 300kg
Maximum gate weight 300kg
Residential housing
Electronic programmer for one motor + battery charger and NiMH batteries
Electronic programmer without batteries and battery charger
7-wire special connecting cable length 2m
Encoder-controlled 24V self-locking unit - max. weight 700kg
Maximum gate weight 700kg
Collective housing
Residential housing
Electronic programmer for one motor + battery charger and NiMH batteries
Electronic programmer without batteries and battery charger
7-wire special connecting cable length 2m
Encoder-controlled 24V self-locking unit - max. weight 1000kg
Maximum gate weight 1000kg
Collective housing
Industial building
Electronic programmer for one motor + battery charger and NiMH batteries
Electronic programmer without batteries and battery charger
7-wire special connecting cable length 2m
Encoder-controlled rapid 24V self-locking unit - max. weight 1000kg
Velocità rapido variabile
Maximum gate weight 1000kg
Collective housing
Residential housing
Electronic programmer for one motor - batteries and battery charger to be ordered separately
7-wire special connecting cable length 2m for DRACO
Encoder-controlled rapid 24V self-locking unit - max. weight 2000kg
Velocità rapido variabile
Maximum gate weight 2000kg
Collective housing
Industial building
Electronic programmer for one motor - batteries and battery charger to be ordered separately
7-wire special connecting cable length 2m for DRACO
